USED MACHINERY

Used SIGMA 65

Manufactured by SCM

DESCRIPTION

This panel saw was manufactured in April 2001, has a new control, and a new PLC. All parts are factory authorized and purchased through SCM parts. A new carriage drive chain was installed about 2 years ago. Run on average about 2 hours per day. Runs like new.

TECHNICAL SPECIFICATIONS

Main motor 10hp
Cut length 10’ 6”
Cut height 2.25”
230 – 440 v 60 hz
3 5ft. air tables / one with fixed fence.
6 gripper clamps that are adjustable
2 carriage feed speeds
Full rear protection wall.
THK guides on rise and fall of blades
Side alignment
“Cutty” on board optimization software
3 sets of blades
One 6,000lb lift table on the front included

PRICING

$35,000 (installation additional)

HAVE QUESTIONS? READY TO PLACE AN ORDER?